Find activities

  • WMTS:533-2021 | Public Comment Draft Round 2

    For Public Comment Technical Specification for the WaterMark Certification Scheme In resolving round 1 public comment for draft WMTS-533, technical changes were identified, which required redrafting. The changes included expansion of the material section and an addition of a... More
    Closed 17 November 2021
  • Consultation RIS - Proposed NCC 2022 residential energy efficiency provisions

    The Australian Building Codes Board (ABCB) is proposing to update the energy efficiency provisions for residential buildings in the 2022 edition of the National Construction Code (NCC). The proposed provisions are included in stage 2 of the NCC 2022 public comment draft (PCD). An... More
    Closed 7 November 2021
  • National Construction Code (NCC) 2022 public comment draft (stage 2)

    The National Construction Code (NCC) is updated every 3 years, based on industry research, public feedback and policy directions from governments to the Australian Building Codes Board (ABCB) between publishing cycles. Updated content is included in the public comment draft (PCD)... More
    Closed 20 October 2021
  • WMTS-531 Commercial catering appliances | Public comment draft

    For Public Comment Technical Specification for the WaterMark Certification Scheme This Technical Specification sets out minimum product requirements for the connection of commercial catering appliances employed for the preparation, cooking, and holding of food to the water... More
    Closed 29 September 2021
  • Inspection and certification of fire safety systems installation

    In 2017, Building Ministers authorised an assessment of the effectiveness of compliance and enforcement systems for the Australian building and construction industry. Recommendation 19 of the resulting Building Confidence Report (BCR) is that each each jurisdiction requires registered fire... More
    Closed 26 September 2021
  • WMTS-533:2021 Wet well washers

    For Public Comment Technical Specification for the WaterMark Certification Scheme This new specification sets out requirements for a prefabricated washing device consisting of a rotating arm with included spray nozzles designed specifically for use with wet wells and tanks. These... More
    Closed 7 September 2021
  • WMTS-534:2021 Metallic pressure differential bypass valves used in heated water systems

    For Public Comment Technical Specification for the WaterMark Certification Scheme This new Technical Specification shall be read in conjunction with AS 1357.2 and sets out the requirements for metallic pressure differential bypass valves used in heated water systems up to DN32. ... More
    Closed 7 September 2021
  • Continuing professional development on the National Construction Code

    In 2017, Building Ministers authorised an assessment of the effectiveness of compliance and enforcement systems for the Australian building and construction industry. Recommendation 3 of the resulting Building Confidence Report (BCR) states that each jurisdiction requires all... More
    Closed 5 September 2021
  • WMTS-040 | Public Comment Draft Round 1

    Technical Specification for the WaterMark Certification Scheme This Technical Specification sets out requirements for metallic and plastics bodied waste pipe outlets and gratings, separate or integral, for sanitary plumbing applications. The objective of this revision is to... More
    Closed 3 August 2021
  • Evidence of experience for building surveyor registration

    In 2017, Building Ministers commissioned an independent expert examination of systemic problems affecting compliance with the National Construction Code (NCC). The resulting Building Confidence Report (BCR) made 24 recommendations for a best practice model for... More
    Closed 19 July 2021
  • National Construction Code (NCC) 2022 public comment draft (stage 1)

    Please note The Australian Building Codes Board (ABCB) wishes to advise that consultation on stage 1 of National Construction Code (NCC) 2022 public comment draft (PCD) has now been extended until 11:59 PM AEST Sunday 11 July. The ABCB is cognisant of the on-going impact on... More
    Closed 11 July 2021
  • WMTS-532 Pre-packaged wastewater pumping wells

    For Public Comment Technical Specification for the WaterMark Certification Scheme This new WaterMark technical specification sets out requirements for pre-packaged wastewater pumping wells to convey wastewater from multiple fixtures from a single dwelling to the gravity sewer invert... More
    Closed 7 July 2021
  • Discussion paper: Involvement of fire authorities in building design

    The Building Confidence Report (BCR), published in 2018, identified issues with the regulatory oversight of the construction of Class 2 - 9 buildings in Australia. It noted that fire authorities lack confidence that buildings will comply with the minimum fire safety requirements of the... More
    Closed 7 July 2021
  • Discussion paper: Draft National Building Product Assurance Framework - A Response to the Building Confidence Report

    In 2017, Building Ministers commissioned an independent expert examination of systemic problems affecting compliance with the National Construction Code(NCC). The resulting Building Confidence Report (BCR) made 24 recommendations for a best practice model for compliance and... More
    Closed 6 June 2021
  • Discussion paper: Building Manuals - A Response to the Building Confidence Report

    The Building Confidence Report (BCR), published in 2018, identified issues with the regulatory oversight of the construction of Class 2 - 9 buildings in Australia. It noted that owners of Class 2 - 9 buildings do not always receive complete information about their buildings, which affects their... More
    Closed 17 May 2021
  • Discussion Paper: Integrity of private building surveyors and their role in enforcement - a response to the Building Confidence Report

    In 2017, Building Minsters authorised an assessment of the effectiveness of compliance and enforcement systems for the building and construction industry across Australia. The resulting Building Confidence Report (BCR) made 24 recommendations for a best... More
    Closed 27 April 2021
  • Special Public Comment - DR AS/NZS 3500.2:2021 Plumbing and drainage, Part 2: Sanitary plumbing and drainage

    Standards Australia WS-014 Committee has released a draft of AS/NZS 3500.2:2021 for third round comment on one particular clause. The draft will be for Combined Procedure (Ballot and PC Round 3 to run concurrently) for 2 weeks Comment will only be invited on the reinstatement... More
    Closed 23 April 2021
  • Consultation RIS: Lead in plumbing products in contact with drinking water

    A small amount of lead is currently used in the manufacture of some plumbing products and is permitted by Australian Standards. The exact lead content of products varies by component, although some products in contact with drinking water contain up to 6% lead as a proportion of raw... More
    Closed 1 March 2021
  • Discussion paper: Independent Third Party Review - A response to the Building Confidence Report

    In 2017, Building Ministers authorised an assessment of the effectiveness of compliance and enforcement systems for the building and construction industry across Australia. The resulting Building Confidence Report (BCR) noted that building surveyors are not always competent to review and... More
    Closed 28 February 2021
  • Discussion paper: Building Design Acceptance - A response to the Building Confidence Report

    In 2017, Building Minsters authorised an assessment of the effectiveness of compliance and enforcement systems for the building and construction industry across Australia. Amongst other recommendations t he resulting Building Confidence Report (BCR) recommended that there be a statutory duty... More
    Closed 28 February 2021
  • Discussion paper: Mandatory Inspections - A response to the Building Confidence Report

    Building Ministers authorised an assessment of the effectiveness of compliance and enforcement systems for the building and construction industry across Australia. The resulting Building Confidence Report (BCR) notes that there are significant differences across jurisdictions in the number of... More
    Closed 28 February 2021
  • Auditing and Compliance Publication Framework

    The Building Confidence Report (BCR), published in 2018, identified there were regulatory and compliance deficiencies in the regulatory oversight of the construction of commercial buildings in Australia. Note the BCR defined commercial buildings as Class 2 – 9 buildings and we have continued... More
    Closed 31 January 2021
  • WMTS:051-2020 Bidet douche seats

    For Public Comment Technical Specification for the WaterMark Certification Scheme WaterMark Technical Specification WMTS-051:2020 Technical Specification for plumbing and drainage products, Bidet douche seats, incorporates amendments to the labelling and marking requirements for... More
    Closed 2 December 2020
  • Definition for building complexity

    The defined term for 'Building complexity' has been developed in response to a decision of the Building Ministers’ Forum (BMF) that a definition be prepared regarding the design, construction and certification of complex buildings. This work has been undertaken by the Building Confidence... More
    Closed 1 November 2020
  • WMTS:101-2020 Appliances (low hazard rating)

    For Public Comment Technical Specification for the WaterMark Certification Scheme The proposed amendments to WaterMark Technical Specification, WMTS-101:2020 Technical Specification for plumbing and drainage products, Appliances (low hazard rating), include amendments to Clause... More
    Closed 28 October 2020
  • WMTS-522:2020

    For Public Comment Technical Specification for the WaterMark Certification Scheme WMTS-522:2020,incorporates amendments to allow an addition of similar products of alternate design to obtain certification. The amendments have also aligned with requirements of existing... More
    Closed 28 October 2020
  • WMTS:530 - Water meters with integral shut off valve

    For Public Comment Technical Specification for the WaterMark Certification Scheme This Technical Specification sets out requirements for water meters with integral shut off valve for installation into existing property service valves. The meters covered by this Technical... More
    Closed 9 September 2020
  • WaterMark Complement to AS 4775

    For Public Comment Complement for the WaterMark Certification Scheme This WaterMark Complement is for use under the WaterMark Certification Scheme and is to be used in addition to the requirements of AS 4775 Emergency eyewash and shower equipment. This WaterMark Complement... More
    Closed 2 September 2020
  • Consultation RIS: Proposal to include minimum accessibility standards for housing in the NCC

    Ways to provide your feedback You can provide your feedback on the Consultation Regulation Impact Statement (RIS) by either: Completing the online consultation form and answering the questions outlined within, or by uploading a separate submission via Question 36 (within the... More
    Closed 31 August 2020
  • Discussion paper: National Registration Framework for Building Practitioners

    The Building Ministers’ Forum (BMF) authorised an assessment of the effectiveness of compliance and enforcement systems for the building and construction industry across Australia. The resulting Building Confidence Report (BCR) highlighted shortcomings in the implementation of the National... More
    Closed 23 August 2020
47 results. Page 1 of 2